This belt is about 1.5 inches wide and 1/4 inch thick (that’s about four stacked quarters).
DOUBLE LAYER STYLE:
Using two layers of the finest U.S. Full Grain leather glued and stitched together for an incredibly durable belt. Most people will find this is the perfect match of durability and versatility. The inner facing layer is always Tan to prevent dye rub off, and the outer layer is your choice.
DOUBLE LAYER + STEEL REINFORCEMENT:
By far the strongest belt around. You can load up this belt with quite a lot and it will resist stretch and warp. I use a high grade of spring steel sandwiched in between the leather starting just before the tightest hole setting and ending just before the chicago screws. The belt is highly resistant to pinching on the width and bowing overall. It’s actually still fairly comfortable to wear.
DOUBLE LAYER + WEBBING:
An alternate to the steel core is the nylon webbing reinforcement. Webbing is known for the fact that it will lessen stretch and when placed inside a double layer full grain belt, it does it’s job well. The leather I use on these belts generally will not stretch much at all after the initial few weeks of break in, but over time if you carry extra items often this may be a good compromise.
To get an accurate size measurement put on your current belt the way you would normally wear it. Then please see the size chart photo for details on how to get your correct belt size by measuring your own belt. Don’t use pants or waist size as it will not work and we cannot exchange or refund for size.
We use an extremely thick thread typically used in the saddle and horse tack industry. It’s meant to be UV resistant and holds up well over time. Currently there are two color options, Natural – which is an off-white color and Black – which may be appropriate for the black colored belts if you prefer.
All buckles are made of solid brass and have an outer finish of your choice. Depending on the belt style and width you choose, certain options may not be available. Currently the black PVD buckles are only available in 1.5″ widths.
On this belt, personalization will go on the back side on the tan liner next to the maker stamp for all double layer belts. For single layer belts I place it between the two chicago screw on the back side of the buckle area.
Note on the handmade process: Numerous tools and machines are used to make this belt, there may be the occasional marking on the leather. If it cuts into the leather, I always replace the piece before shipping out. Once in a long while the sewing machine will ‘skip a stitch’ resulting in one slightly longer stitch about a fraction of a millimeter in length. In order to remedy this I cut that stitch out, and re-stitch about 3 stitches before and 3 after. This in turn technically makes it even stronger and you may not even notice it. Again – it is a very rare occurrence, but part of the trade and worth putting here.
Discounts: Due to the amount of work required to make this type of belt it may not be eligible for the same discounts as other items in the shop.